Common Faults of Waste Hammer Crusher

Common faults of Waste Hammer Crusher
Common uses of hammer crushers are mainly used in many industrial sectors to carry out materials and other steps. It can be seen that the hardness of the materials crushed by the machine in daily operations is different. In the face of materials of different hardness, the crusher needs to ensure that the efficiency of the machine is high if it wants to meet the requirements.
The following are common faults in Waste Hammer Crusher:
Fault 1: Vibration
1. The Waste Hammer Crusher and the motor are installed on different shafts.
Solution: Correction and adjustment to make it meet the technical requirements of installation.
2. Unbalanced rotor
Solution: rearrange the ring hammer.
3. The feed block is too large
Solution: Control the lumpiness of the material.
4. The bearing seat or anchor nut is loose
Solution: Tighten the nut and do not loosen it.
Trouble two: reduced output
1. The gap between the rotor and the sieve plate is too large
Solution: Adjust the spring bolt.
2. Wear of ring hammer
Solution: repair or replace the ring hammer.
Trouble three: abnormal sound in the Waste Hammer Crusher
1. Materials or metals that cannot be crushed enter the crushing cavity
Solution: clean the crushing cavity.
2. Internal parts activities
Solution: Check carefully and tighten in time.
3. Internal parts are broken
Solution: Check carefully and replace the broken parts.
4. The rotor collides with the sieve plate
Solution: Adjust the gap between the rotor and the sieve plate.